Intermec EasyCoder PM4i Installation Instructions Manual page 15

13
[View from above] Connect the antenna cable to the adapter cable (3).
Reassembly
1 Reattach the console cable to the CPU board while putting back the
cover over the electronics compartment. Fasten the four screws in the
center deck.
2 Tip the printer over on its side. Insert and fasten the screws in the
empty holes in the bottom plate.
3 Store remaining components (the original paper guide and other
hardware that had to be removed prior to installation) for possible
future use.
RFID Kit (Gen 2, 869/915 MHz) Installation Instructions 9