Table of Contents
Advertisement
Power Requirements
able Lead
Identification
Mating onnectors
aution
onnecting an
85037A/B
he scalar network analyzer supplies power for the detector.
When you use more than one detector, use the coded cable clips
(from the cable marker kit) to identify leads; place matching clips on
each cable, one at each end.
able 1-3 lists connector mechanical tolerances.
Connector Care Quick Reference Card
information on the proper maintenance, inspection, and gaging of
connectors. Use the appropriate torque wrench. (See able 1-4.)
When tightening a connector, do not apply more than the
recommended torque value. If you torque the connectors with more
pressure than is recommended it can deform the mating surfaces.
Connect a detector to the network analyzer as follows:
1. With the cable plug key downward, insert the DC connector into
the analyzer mating connector.
2. o secure the DC connector in the analyzer, turn the
clockwise.
3. For a standard detector, connect the RF input by turning the
male connector
4. For a precision (Option 001) 7 mm connector, refer to Figure 2-2.
Figure 2-2. Using Precision 7 mm Connectors
(08510-90360) provides
shell clockwise.
outer
Microwave
shell
outer
Installation 2-3
Advertisement
Table of Contents
