Table of Contents
Advertisement
Installation, Operation, & Maintenance Manual
ES-09374-1
2 - The rotary support is factory assembled for actuators with 30x80 holes and 30mm
shaft height. If you need to modify these measures, refer to item 5.3.1 - Mounting the
Rotary Support to the Actuator.
6.3
Pneumatic Connection on Linear Actuator
Figure 5-7 Universal Rotary Mounting Kit
Check below the pneumatic connection for each type of linear actuator.
Figure 6-5 Pneumatic Connections on Linear Actuators
3 - Mount the bracket to the positioner by placing the four M6x10 screws with lock
washers and plain washers. Tighten the screws with a 10 mm wrench.
Figure 5-8 Mounting the Bracket on the Positioner
ATTENTION
The positioner can be installed at any starting angle and operates in any position,
vertical or horizontal.
CAUTION
Be careful when handling compressed air hoses, make sure the line is disconnected
before connecting it to the positioner.
IMPORTANT
The positioner can be installed at any starting angle and operates in any position,
The unused outlet must be capped.
vertical or horizontal.
Mechanical Installation
Pneumatic Connections
Pneumatic Connections
August 23, 2022
13
33
Advertisement
Table of Contents
