Table of Contents
Advertisement
Installation, Operation, & Maintenance Manual
ES-09374-1
4 - Mount the positioner with bracket by engaging the positioner end cap on the shaft of
the rotary actuator, attach the four M5x10 screws with lock washers and plain washers.
Tighten the screws with an 8 mm wrench.
Figure 5-9 Fitting on the Actuator Shaft
Figure 5-10 Tightening the Bracket Bolts
5 - Make the pneumatic and electrical connections. See Section 6 - Pneumatic
Connections and Section
6 - Perform a fast calibration. See
Mechanical Installation
7 - Electrical Connections.
Section 8.3
- Fast Calibration.
Mechanical Installation
August 23, 2022
19
Advertisement
Table of Contents
