Table of Contents
Advertisement
Development Kit User Guide
9. To get NMEA output, connect a USB cable to USB0.
10. Connect a 4V power supply unit to CN402.
Note:
Make sure that Pin 2 and Pin 3 of CN403, as well as
Pin 1 and Pin 2 of CN402 are connected with a
jumper when using a 4V power supply unit.
Alternatively, a lab power supply can be connected
to CN401 and CN400. (If using a lab power supply, it
is recommended to set it to 3.7V with 4A output to
prevent failure at power on.)
Note:
Make sure that Pin 1 and Pin 2 of CN403, as well as
Pin 2 and Pin 3 of CN402 are connected with a
jumper when using a lab power supply.
The AirPrime HL Series Development Kit should look like the following figure after it has been
properly set up.
Figure 25.
AirPrime HL Series Development Kit with an HL6528 Embedded Module Inside the Snap-in Connector
4114877
Rev 5.0
Getting Started with the HL Series
Development Kit
October 12, 2015
35
Advertisement
Table of Contents
