Table of Contents
Advertisement
Available languages
Available languages
CHAPTER 4. BEFORE USING THE APPLIANCE
PREPARING YOUR DISHWASHER FOR FIRST USE
•
Make sure the electricity and supply water specifications match the values indicated in the
installation instructions for the machine.
•
Remove all packaging material inside the machine.
•
Set the water softener level.
•
Fill the rinse aid compartment
SALT USAGE (IIF AVAILABLE)
For a good washing function, the dishwasher needs soft, i.e. less calcareous water. Otherwise, White lime
residues will remain on the dishes and the interior equipment. This will negatively affect your machine's
washing, drying and shining performance. When water flows through the softener system, the ions forming
the hardness are removed from the water and the water reaches the softness required to obtain the best
washing result. Depending on the level of hardness of the inflowing water, these ions that harden the water
accumulate rapidly inside the softener system. Therefore, the softener system has to be refreshed so that it
operates with the same performance also during the next wash. For this purpose, dishwasher salt is used.
Machine can only be used by special dishwasher salt to soften the water. Do not use any small grained or
powdered type of salts which can easily soluble. Using any other type of salt can damage your machine.
FILL THE SALT (IF AVAILABLE)
To add softener salt, open the salt compartment cap by turning it counter clockwise. (1) (2) At first use, fill the
compartment with 1 kg salt and water (3) until it is almost overflowing. If available, using a funnel (4) will
make filling easier. Replace the cap and close it. After every 20-30 Cycles add salt into your machine until
it fills up (approx. 1 kg).
Only add water to the salt compartment on first use.
Use softener salt specifically produced for use in dishwashers. When you start your dishwasher, the salt
compartment is filled with water, therefore put the softener salt in prior to starting your machine.If the
softener salt has overflowed and you do not start the machine immediately, run a short washing program to
protect your machine against corrosion.
1
3
2
4
43
Advertisement
Chapters
Table of Contents
