Step 3 - WCP SS Swerve (BLDC) User Manual

WCP SS Swerve (BLDC)- User Guide
(Rev 1)

Step 3

This step requires the previously assembled wheel module. The module is installed from
the bottom of the plate. The wheel module should be a tight slip fit and may require a
bit of rocking from side to side to get fully seated. The bearing should sit flush with the
plate.
Once the module is fully in, use the 8 #10-32 x 3/8"L bolts to capture the bearing. If the
bearing was not fully seated, these bolts should push the bearing fully in.
WCP SS Swerve (BLDC)- User Guide (Rev 1) Page 17
wcproducts.com