Humanscale Path Chair Disassembly Instructions Manual page 20

Path Chair
Tools Required
Complete Disassembly of Connector
Step 1
Use a T-30 Torx bit to remove (2) screws.
Step 2
Place punch or screwdriver in access holes indicated
by arrows to left and hammer the punch or
screwdriver to remover rear rollers and axles (2X).
Step 3
Using a flat bladed screwdriver and hammer, from
the underside (as pictured in bottom right), extract
dowel pins. This will allow removal of the spring
plunger.
Step 4
Unwind springs off of spring plungers (2X).
Some components may not be recyclable in your area.
Disassembly Instructions
Safety Glasses Flat Screwdriver T-30 Torx Bit Hammer
Glass Filled Nylon
GF
1
Rear Rollers and Axles (x2)
POM
>POM<
Steel
Spring Plungers (x2)
>POM<
Connector Cover
Access Hole
POM
3
Steel
4
Spring
Steel
REV-00