Settings - Monoprice MP Voxel Pro User Manual

the Extruder to the target temperature. Follow the on-screen instructions to
remove the old filament, then insert the new filament into the filament intake until
some resistance is felt, but do not push it into the tube. When filament comes out
of the Extruder, loading is complete. Remove the extruded filament.
5. Touch the
heat the Extruder to the target temperature. Select the amount of filament to
extrude (100, 200, or 300 mm) when loading. Touch the Load or Unload buttons to
manually load or unload filament.
Note that Manual loading is preferred when there is remaining filament in the tube.

Settings

Perform the following steps to adjust the printer's settings.
1. Touch the Settings icon on the Main Menu. The system will display the Settings
screens.
2. You can perform the following actions on the Settings screens:
Move: Moves the extruder left or right or moves the build plate forward or
back, up or down. It is normal for noise to occur when the extruder is moved
Manual icon to manually load or unload filament. The system will
21