3 Mounting
Tools
Position in the housing
Mounting of the plug con-
nector
6
3
Mounting
3.1
Mounting preparations
The following tools are required for mounting:
•
Spanner SW 24 for unscrewing the cable gland
•
Screwdriver SW 24 for tightening the counternut
3.2
Installation procedure
The following illustration shows the position of the plug connector in
the respective housing:
1
2
1
5
Fig. 3: Position of the plug connector on different instrument versions
1
Plug connector
2
Plastic single chamber
3
Stainless steel single chamber (electropolished)
4
Stainless steel single chamber (precision casting)
5
Aluminium - single chamber
6
Stainless steel double chamber (precision casting), aluminium
7
Stainless steel double chamber (precision casting), aluminium with ad-
ditional current output
Proceed as follows to mount the plug connector:
1. Open the cover of the electronics or connection compartment
2. Unscrew the cable gland
3. Screw in the plug connector and secure it with the counternut
4. Connect the wires according to chapter "Connect"
The mounting of the plug connector is finished.
Disassembly is carried out in reverse order.
Plug connector Harting HAN 8D • for continuously measuring sensors
1
3
6
1
1
4
7
1
1