Table of Contents
Advertisement
Plug connector Harting HAN 8D • for continuously measuring sensors
4
Connecting to power supply
4.1
Connection procedure
Proceed as follows:
1. Loosen the screw on the rear of the connector housing
2. Remove the socket insert from the connector housing
1
Fig. 4: Loosen the socket insert
1
Socket insert
2
Screw
3
Connector housing
3
Cable gland
3. Remove approx. 5 cm of the cable mantle, strip approx. 1 cm
insulation from the individual wires
4. Lead the cable through the cable gland into the plug housing
5. Solder the wire ends ito the contact socket according to the wiring
plan
1
Fig. 5: Insert contact socket
1
Individual contact socket
2
Crimp connection
3
Wire end
4
Contact sleeves, plug side
6. Snap the contact socket from the rear into the socket insert
7. Screw the socket insert into the connector housing
8. Put the screwed housing and the connector housing together and
close the safety catch
4 Connecting to power supply
2
3
3
2
4
4
3
4
5
2
1
8
7
6
7
Advertisement
Table of Contents
