Trim Meter; Trim Meter (Digital Type); Hour Meter (Digital Type) - Yamaha 40V Owner's Manual

ther information on reading the indicator, see
page 20.
ECM00050
CAUTION:
Do not continue to run the engine if the
overheat warning indicator is on. Serious
engine damage will occur.
1
1. Overheat warning indicator
EMU26610

Trim meter

This gauge shows the trim angle of your out-
board motor.
NOTE:
Memorize the trim angles that work best for
your boat under different conditions. Adjust
the trim angle to the desired setting with the
power trim and tilt switch.
EMU26620

Trim meter (digital type)

This meter shows the trim angle of your out-
board motor.
NOTE:
Memorize the trim angles that work best
G
for your boat under different conditions.
Adjust the trim angle to the desired using
the power trim and tilt switch.
If the trim angle of your motor exceeds the
G
trim operating range, the top segment on
the trim meter display will blink.
ZMU01868
EMU26650

Hour meter (digital type)

This meter shows the number of hours the
engine has been run. It can be set to show
the total number of hours or the number of
hours for the current trip. The display can
also be turned on and off.
ZMU04581
Changing the display format
G
Basic components
ZMU01869
ZMU01870
19