Trim Meter; Trim Meter (Digital Type); Hour Meter (Digital Type) - Yamaha F40D Owner's Manual

1. Cap
2. Selector switch (for speed unit)
3. Selector switch (for fuel sensor)
EMU26610

Trim meter

This gauge shows the trim angle of your out-
board motor.
NOTE:
Memorize the trim angles that work best for
your boat under different conditions. Adjust
the trim angle to the desired setting with the
power trim and tilt switch.
EMU26620

Trim meter (digital type)

This meter shows the trim angle of your out-
board motor.
NOTE:
Memorize the trim angles that work best
G
for your boat under different conditions.
Adjust the trim angle to the desired using
the power trim and tilt switch.
If the trim angle of your motor exceeds the
G
trim operating range, the top segment on
the trim meter display will blink.
EMU26650

Hour meter (digital type)

This meter shows the number of hours the
engine has been run. It can be set to show
the total number of hours or the number of
hours for the current trip. The display can
also be turned on and off.
ZMU04581
Changing the display format
G
Pressing the "
G
es the display format in the following pat-
tern:
Total hours→Trip hours→Display off
G
Resetting the trip hours
G
Simultaneously pressing the "
G
and "
1 second while the trip hours are displayed
Basic components
" (mode) button chang-
" (mode) buttons for more than
ZMU01740
ZMU01741
" (set)
25