Choke Knob For Pull Type; Manual Starter Handle; Main Switch; Steering Friction Adjuster - Yamaha 40V Owner's Manual

EMU26011

Choke knob for pull type

To supply the engine with the rich fuel mix-
ture required to start, pull out this knob.
EMU26070

Manual starter handle

To start the engine, first gently pull the han-
dle out until resistance is felt. From that posi-
tion, then pull the handle straight out quickly
to crank the engine.
EMU26090

Main switch

The main switch controls the ignition system;
its operation is described below.
"
G
With the main switch in the "
tion, the electrical circuits are off, and the key
can be removed.
"
G
ZMU03354
With the main switch in the "
tion, the electrical circuits are on, and the key
cannot be removed.
"
G
With the main switch in the "
sition, the starter motor turns to start the en-
gine. When the key is released, it returns
automatically to the "
ZMU03355
EMU26110

Steering friction adjuster

A friction device provides adjustable resis-
tance to the steering mechanism, and can be
set according to operator preference. An ad-
juster lever is located on the bottom of the
tiller handle bracket.
To increase resistance, turn the lever to the
left.
To decrease resistance, turn the lever to the
right.
EWM00040
WARNING
ZMU02942
Do not overtighten the friction adjuster. If
there is too much resistance, it could be
Basic components
" (off)
" (on)
" (start)
" (on) position.
" (off) posi-
" (on) posi-
" (start) po-
13