Yamaha 40V Owner's Manual page 49

1. Place the remote control lever / the gear
shift lever in neutral.
2. Disconnect the fuel line from the out-
board motor or close the fuel cock.
3. Press the power trim and tilt switch /
power tilt switch "
board motor has tilted up completely.
UP
UP
DN
ZMU03108
" (up) until the out-
ZMU01935
4. Push the tilt support knob into the clamp
bracket or pull the tilt support lever to-
ward you to support the engine.
EWM00260
WARNING
After tilting the outboard motor, be sure
to support it with the tilt support knob or
tilt support lever. Otherwise the outboard
motor could fall back down suddenly if oil
in the power trim and tilt unit loses pres-
sure.
5. Models equipped with trim rods: Once
the outboard motor is supported with the
tilt support lever, press the power trim
and tilt switch "
trim rods.
ECM00250
CAUTION:
Be sure to retract the trim rods complete-
ly during mooring. This protects the rods
Operation
UP
ZMU04993
ZMU03115
" (down) to retract the
43