Adjusting Trim Angle For Manual Tilt Models - Yamaha 40V Owner's Manual

Operation
also affected by variables such as the load in
the boat, sea conditions, and running speed.
EWM00740
WARNING
Excessive trim for the operating condi-
tions (either trim up or trim down) can
cause boat instability and can make
steering the boat more difficult. This in-
creases the possibility of an accident. If
the boat begins to feel unstable or is hard
to steer, slow down and/or readjust the
trim angle.
1. Trim operating angle
EMU27871
Adjusting trim angle for manual tilt
models
There are 4 or 5 holes provided in the clamp
bracket to adjust the outboard motor trim an-
gle.
1. Stop the engine.
38
1
ZMU03109
2. Remove the trim rod from the clamp
bracket while slightly tilting the outboard
motor up.
1. Trim rod
1. Trim rod
3. Reposition the rod in the desired hole.
To raise the bow ("trim-out"), move the rod
away from the transom.
To lower the bow ("trim-in"), move the rod to-
ward the transom.
Make test runs with the trim set to different
angles to find the position that works best for
your boat and operating conditions.
EWM00400
WARNING
Stop the engine before adjusting the
G
trim angle.
Use care to avoid being pinched when
G
1
ZMU03402