Table of Contents
Advertisement
Instruments and indicators
EMU26493
Digital tachometer
The tachometer shows the engine speed
and has the following functions.
All segments of the display will light momen-
tarily after the main switch is turned on and
will return to normal thereafter.
1
3
5
6
1. Tachometer
2. Trim meter
3. Hour meter
4. Oil level indicator
5. Overheat-alert indicator
6. Set button
7. Mode button
TIP:
The water separator and engine trouble-alert
indicators only operate when the engine is
equipped with the appropriate functions.
EMU36050
Tachometer
The tachometer displays engine speed in
hundreds of revolutions per minute (r/min).
For example, if the tachometer display reads
"22" then the engine speed is 2200 r/min.
EMU26621
Trim meter
This meter shows the trim angle of your out-
board motor.
Memorize the trim angles that work best
for your boat under different conditions.
Adjust the trim angle to the desired using
28
the power trim and tilt switch.
If the trim angle of your motor exceeds the
trim operating range, the top segment on
the trim meter display will blink.
2
EMU26651
4
Hour meter
7
This meter shows the number of hours the
ZMU01891
engine has been run. It can be set to show
the total number of hours or the number of
hours for the current trip. The display can
also be turned on and off.
To change the display format, press the
"
total hours or trip hours, or turn off.
To reset the trip hours, simultaneously press
the "
more than 1 second while the trip hours are
displayed. This resets the trip counter to 0
(zero).
The total number of hours the engine has
been run cannot be reset.
" (mode) button. The display can show
" (set) and "
" (mode) buttons for
ZMU01869
ZMU01870
Advertisement
Table of Contents
