Kanguru DVD Duplicator User Manual page 12

Also, the system will read from this partition to get the source data. If you want to load more than
one DVD or CD onto the hard drive you must create a new partition for each DVD or CD.
Please follow these instructions to load multiple DVDs or CDs onto the hard drive.
Image #1
1. Begin by entering the Setup Mode and checking the partition name. It should be 00000
by default.
2. Exit the Setup Mode and scroll to the Load function.
3. Insert your source DVD or CD and wait for the system to recognize it.
4. Press RUN to load the data onto partition 00000.
Image #2
1. Enter the Setup Mode and scroll to the Partition NA. Function.
2. Change the Partition NA. to 00001.
3. Exit the Setup Mode and scroll to the Load function.
4. Insert your source DVD or CD and wait for the system to recognize it.
5. Press RUN to load the data onto partition 00001.
Please note: If you want to load a second image onto the internal hard drive you MUST
first create a new partition name or the new image will be loaded over the first. If you wish
to duplicate from a particular partition, you must also define that partition before
beginning the duplication.
It's a good practice to keep a sheet handy with your partition names and what they contain.
• SHOW DISC INFO
This function shows all of the information on the discs in the drives.
• SHOW EXE TIME [ ]
This function displays the time it takes to duplicate a DVD or CD.
• AUTO EXE TIME [ ]
This function sets a time period (in seconds) in which the duplication process will automatically
begin if there is a blank disc and a source detected. This is used in Standalone Mode only.
• DISABLE SEND OPC [ ]
DO NOT enable this function unless instructed by a Kanguru Solutions tech support rep.