Kanguru DVD Duplicator User Manual page 11

• DVD READING SPEED
Set the reading speed of the source drive.
Usable speed can be: "MX", "01", "02", "2.4", "04", "06", "08, 16".
"MX" indicates the maximum speed. If you set this value to a value higher than the maximum
speed of your writer, your writer will operate at its maximum speed.
"MD" the reader uses the source disc media speed (default speed of disc), to read the source
disc.
The default value is: "MX".
• CD WRITING SPEED
Set the writing speed of your writers.
Usable speed can be: "MX", "MD, "01", "02", "03", "04", "06", "08", "10",
"12", "16", "20", "24", "32", "40" "46", "48", and "52".
"MX" indicates the maximum speed. If you set this value to a value higher than the maximum
speed of your writer, your writer will operate at its maximum speed.
"MD" the writers use the source disc media speed (default speed of disc), to read the source
disc.
The default value is: "MX".
• DVD WRITING SPEED
Set the writing speed of your writers.
Usable speed can be: "MX", "MD, "01", "02", "2.4", "04", "06", "08, 16"
"MX" indicates the maximum speed. If you set this value to a value higher than the maximum
speed of your writer, your writer will operate at its maximum speed.
"MD" the writers use the source disc media speed (default speed of disc), to read the source
disc.
The default value is: "MX".
• SET AS DEFAULT
The Kanguru DVD controller will save all changes of the settings made. If you want to restore the
factory setting (default setting) push the "SET" button to select this setting and then push the
"RUN" button to restore the default settings.
• UPDATE FIRMWARE—N/A
DO NOT USE THIS FUNCTION UNLESS INSTRUCTED TO DO SO BY A
KANGURU SOLUTIONS TECHNICIAN.
• TOTAL DISC COUNT
Displays a master record of the total discs duplicated.
• CHECK TRK LEN
This function is for the controller to read and detect the bad sector location.
1. "NO" doesn't use GAP to read.
2. "AUTO" uses a standard GAP to read.
3. "SHORT" uses a short GAP to read.
4. "LONG" uses a long GAP to read.
• PARTITION NA. [00000]
This is setting allows you to name each partition on your hard drive to load multiple DVD or CD
images. By default the Autoloader is set to read and load from Partition 00000. This means that
any data loaded onto the hard drive will be loaded into the first partition on the hard drive [00000].