Shimano ALFINE Inter-11 Dealer's Manual page 39

MAINTENANCE
Replacement and assembly of the indicator unit
For internal 11-speed
Removal
(B)
(A)
Installation
(A)
1
(B)
(C)
(G)
Secure the indicator unit with the three cover fixing screws.
2
Operate the main and the release levers, to check their operation.
3
If they do not operate correctly, reinstall the indicator unit while taking particular note of
step 1.
Operate the release lever 10 times or
more to set it to 11 .
Loosen and remove the three cover
(C)
fixing screws which are securing the
indicator unit.
Remove the indicator unit as shown in
the illustration.
(B)
Check that the needle of the indicator is
on the left side ( 11 position), and then
(D)
install the indicator unit so that it is
facing straight upward.
At this time, check that the main axle is
installed in the cam unit hole and that
the pin of the cam unit is installed in the
(E)
winder unit hole, and then insert the
indicator shaft protruding from the
(F)
bottom of the indicator unit into the
groove of the cam unit.
39
(A)
Release lever
(B)
Cover fixing screws
(C)
Indicator unit
(A)
Indicator shaft
(B)
Cam unit groove ( 11 position)
(C)
Cam unit pin
(D)
Indicator unit
(E)
Cam unit hole
(F)
Main axle
(G)
Winder unit hole
Tightening torque
0.3 - 0.5 N·m