Radyne ComStream DM240-DVB Installation And Operation Manual page 34

DM240-DVB High-Speed Digital Modulator
MODEM EADDR:
ETHER RATE:
SNMP (Menu):
Trap Version:
Authorization:
RD COMMUNITY:
RDWR COMMUNITY:
TERMINAL (menu)
TYPE:
BAUD RATE:
HW/FW CONFIG (menu)
DM240:
TM083 – Rev. 3.0
{001065FFFFFF}
Displays the Ethernet address of the device. Set at the
factory and is a unique identifier for the Ethernet physical
interface.
{10 Mbps/HD/FD, 100 Mbps/HD/FD}
The data rate for the local Ethernet Interface.
10 Mbps/HD/FD – for 10 Base-T in either half-duplex or
full duplex.
100 Mbps/HD/FD – for 100 Base-T in either half-duplex
or full duplex.
{V1, V2}
This controls the message format used when
a message trap is generated by the equipment
and bound for a SNMP host. Messages will only be sent
if the unit has been authorized to do so.
{TRAPS OFF, TRAPS ON}
This controls the message format used when
a message trap is generated by the equipment
and bound for a SNMP host. Messages will only be sent
if the unit has been authorized to do so.
{16 characters of name}
This menu is only displayed when SNMP VERSION is
set to V1 & V2.
This is the community that a host must be acting within
when an OID variable is requested by a V1/V2 SNMP
message.
{16 characters of name}
This menu is only displayed when SNMP version is set
to V1&V2.
This is the community that a host must be acting within
when an OID variable is being changed by a V1/V2
SNMP message.
{VT100, VIEWPOINT, WYSE50}
{300, 600, 1200, 2400, 4800, 9600, 19200, 38400,
57600}
Allows the user to enter the Terminal Baud Rate.
{"Status Only"}
Displays the DM240 feature level (e.g. Series 400)
User Interfaces
4-15