Radyne ComStream DM240-DVB Installation And Operation Manual page 33

User Interfaces
SERVER IP ADDR:
ROUTER IP ADDR:
4-14
DM240-DVB High-Speed Digital Modulator
{XX.XX.XX.XX}
The IP Address of the Boot Server and the address of
the SNMP Trap Server when SNMP is active. If a server
is used and there is no local router, this address must be
consistent with the modem address. If a router has been
specified, the address is presumed to be reachable via
the router. For example:
For the modem 172.18.100.212
No router, and server: 172.18.28.253
Mask: FF.FF.00.00
Modem: AC.12.64.D4
Router: AB.00.00.01
Server: AC.12.1C.FD
For the modem 172.18.100.212
Router on the same network: 172.18.1.5 and
server on a different network: 196.24.14.250
Mask: FF.FF.00.00
Modem: AC.12.64.D4
Router: AC.12.1.5
Server: C4.18.E.FA
Broadcast and loop back addresses will not be allowed.
These are addresses with all subnet bits set to 0's or 1's.
{XX.XX.XX.XX}
The IP Address of the Local Network Router. If a router
is present on the local network, this address must be
consistent with the IP Mask and the subnet of the
modem. If no router is present, then the address should
be set to a foreign address. This address is expressed
in hexadecimal format. For example:
For the modem 172.18.100.212
No router, and server: 172.18.1.5
Mask: FF.FF.00.00
Modem: AC.12.64.D4
Router: AC.12.1.5
For the modem 172.18.100.212
With no local router
Mask: FF.FF.00.00
Modem: AC.12.64.D4
Router: A0.00.00.01
Broadcast and loop back addresses will not be allowed.
These are addresses with all subnet bits set to 0's or 1's.
TM083 - Rev. 3.0