Radyne ComStream DM240-DVB Installation And Operation Manual page 32

DM240-DVB High-Speed Digital Modulator
TCP/IP (Menu):
BOOT MODE:
BOOTp SERVER TAG:
IP ADDR MASK:
MODEM IP ADDR:
TM083 – Rev. 3.0
{Default, NonVol, Bootp}
Default: If no Ethernet Interface is to be used. No IP
Address or mask changes will be allowed.
NonVol: Stores and uses IP Mask and addresses as
provided by the user.
Bootp: At boot time, use Bootp Protocol to get names,
masks, and IP Addresses of the modem, router, and
server.
{128 – 257, default is 206}
Only used if Bootp is selected in Boot Mode. Should be
consistent with the tag expected by the users Bootp
Server.
{FF.XX.XX.XX}
The IP Address Mask of the local network. The mask is
expressed in a hexadecimal format, and must be a valid
TCP/IP Mask.
XX.XX.XX can start with F, E, C, 8, or 0. Once a
character other than F is encountered, all remaining
fields must be zero. For example:
FF.FF.FF.80
FF.FF.FC.00
FF.00.00.00
This field should be set before changes are made to the
Modem or Router Address.
{XX.XX.XX.XX}
The IP Address of the modem. This address should be
consistent for the mask defined. This address is
expressed in hexadecimal format. For example:
For the decimal Modem IP Octets:
172.18.100.212
Mask: FF.FF.0.0
Modem IP Address: AC.12.64.D4
Broadcast and loop back addresses will not be allowed.
These are addresses with all subnet bits set to 0's or 1's.
User Interfaces
4-13