Frame Width; Seat Pan; Attendant Wheel Lock - Sunrise Medical QUICKIE ACCESS EIR14 Owner's Manual

®
Quickie ACCESS
S. FRAME WIDTH
Rear suspension can aff ect the stability of the wheelchair. To avoid a fall, use a spotter and/or antitips when
becoming familiar with new equipment.
1. Width Adjustable Strut Tubes (Seat Frame)
a. Remove the hardware (K) from all three strut tubes, and front portion of Access module.
Adjust both seat rails in or out an equal distance.
b. When both seat rails are adjusted equally, tighten all the hardware (K) to a torque
setting of 17 Nm [150 in-lbs].
2. Width Adjustable Cross Tube Weldments (Base Frame)
a. To adjust the width of the Base Frame, you will need to adjust the front and rear legs in or out
to desired location.
b. You will need to adjust equally, the Front Caster Legs and Rear Legs in or out in relation to both
the Front and Rear Cross Tube Weldments.
52
T. SEAT PAN
The seat pan of the Access is designed to accommodate depth adjustment.
1. Depth adjustment:
a. Loosen and remove all bolts (A).
b. Loosen bolts (B).
c. Adjust the seat pan to the desired depth.
d. Replace and tighten all bolts.
NOTE– Use the holes that place the bolts as far away from each other as possible.
2. Width adjustment
a. Loosen and remove all bolts (B).
b. Adjust chair to the desired width.
c. Replace and tighten all bolts.
U. ATTENDANT WHEEL LOCK
1. Adjust the cable adjustment screws (A) as necessary to ensure that the wheel locks can get to their
fully extended position when the pedal is engaged. Position of the Attendant Wheel Lock Assembly
may need to be fi ne-tuned to optimize the force needed to engage the pedal, depending on tire type.
If excessive force is needed to engage the pedal, cable life may be reduced. Once proper adjustment
is attained, lock cable adjustment screw (A) in position by tightening jam nuts against mounting block.
2. Additional adjustment of the Attendant Wheel Lock is also possible by adjusting position of wheel
lock clamps (B) on slide blocks (C).
252849 Rev. B
™
53 54
IX. DEALER SERVICE AND ADJUSTMENT
50
TORQUE !
0
51
26
K
K
Rear Cross
Tube Weldment
Access
Module
Rear Leg
Front
Front Cross
Caster
Tube Weldment
Leg
A B
B
A
B
C
50
K
51
52
A
53
54
C