Table of Contents
Advertisement
IX. DEALER SERVICE AND ADJUSTMENT
3.
Axle Position Adjustment
a.
Remove both wheels from the chair.
b.
Remove the bolts (A) from the axle plate (B) on both sides of the chair.
c.
Reposition the axle plate in desired position.
d.
Insert and tighten bolts (A).
4.
Axle Height Adjustment
a.
Loosen and remove bolts (A).
b.
Set axle at desired height using pre-set holes in the axle plate (B) on both sides.
c.
Replace and tighten bolts.
E. HUB LOCK ADJUSTMENT
To adjust the cables
1.
Loosen jam nut (C) using a 10mm wrench.
2.
Turn adjustment screw (D) in or out as necessary. Turning screw upward will loosen cable, turning
downward will tighten cable.
3.
Tighten again jam nut (C) against lever mount.
4.
Repeat steps 1-3 for opposite side of chair as necessary.
To adjust lever position
1.
Remove socket screw (E) and washer (F) from lever and backrest.
2.
Choose desired hole in backrest to mount lever and fasten again screw and washer.
3.
Repeat steps 1-2 for opposite side of chair.
F. WHEEL LOCKS
Adjustment
1.
Loosen the upper and lower screws (G).
2.
Slide wheel lock and clamp assembly forward or back along the lower slide block to allow wheel lock
to embed correctly into the tire to prevent wheel movement, when in the locked position.
3.
Tighten screws (G).
G. DRUM BRAKES
Drum brakes permit safe and convenient braking for an attendant. Squeeze the lever (H) to help assist with
braking. Drum brakes are not infl uenced by air pressure inside the tires.
•
Risk of injury: Do not get your fi ngers caught in the brake mechanism.
•
Drum brakes must only be adjusted by a Sunrise Medical authorized dealer.
•
Always operate the two drum brakes simultaneously to guarantee the control of the driving
direction!
•
Drum brakes can only be used as a dynamic brake to stop the wheelchair while driving.
•
Always engage the wheel locks to secure the wheelchair during a short or long stop, or for transfer.
31
31
32
33
34
WARNING
21
®
Quickie
ACCESS
33
H
252849 Rev. B
™
31
32
34
Advertisement
Table of Contents
