For Go/No-Go Testing - Agilent Technologies N9360A Quick Reference Manual

W-CDMA System
5

For Go/No-Go Testing

5-2
Figure 5-1 [Automatic Test: Stand-by] Screen
Press the Automatic Test softkey on the [Initial] screen for
1
W-CDMA system.
Move the cursor to the "Procedure" field, and select a
2
pre-defined test procedure.
Press the Start softkey.
3
Turn the mobile phone on. Wait for completion of Location
4
Update.
Operate the mobile phone as instructed in the table below.
5
Each test flow step is highlighted as it runs.
After completing the test, check the results on the screen.
6
To print the measurement results or to save them into a USB
7
memory device, press the More (1 of 2) softkey and then the
Print Screen softkey.
N9360A Multi UE Tester Quick Reference Guide