Table of Contents
Advertisement
SECTION 4
DANGER
When closing the rear grain chute gate or the walls take particular care to avoid crushing
fingers.
Bulk materials loaded in excess of 1 m can be unloaded by tipping the load box to the rear
only.
Ensure that during unloading nobody is near tipped load box or load material pouring out.
Tipping may only be performed when trailer is hitched to tractor.
Do NOT tip load box in strong gusty winds conditions.
Do NOT move off or drive when load box is raised.
While unloading bulky materials be especially careful. Do NOT tip load box on uneven or wet
ground and move and jerk trailer during unloading. Bulky materials are normally difficult to
unload therefore proceed cautiously and patiently. Careless operation of trailer may pose
a danger to operators and bystanders can also cause damage to the machine.
4.7 PROPER USE AND MAINTENANCE OF TYRES
• When working on the tyres, chocks or other objects without sharp edges should
be placed under the wheels of the trailer to prevent it from rolling. Wheels can be
taken off the trailer axle only when the trailer is not loaded.
• Repair work on the wheels or tyres should be carried out by persons trained and
entitled to do so. This work should be carried out using appropriate tools.
• Inspect tightness of nuts before first use of trailer, after first travel under load and
then every 6 months of use or every 25,000 km. In the event of intensive work
check the nut tightening at least every 100 km. The inspection should be repeated
individually if a wheel has been removed from the wheel axle.
• Regularly check and maintain correct pressure in tyres according to Operator's
Manual (especially if trailer is not used for a longer period).
• Pressure and tyres should be also checked after the whole day of intensive work.
Please note that higher temperatures could raise tyre pressure by as much as 1
bar. At high temperatures and pressure, reduce load or speed.
4.25
Pronar T683
Advertisement
Table of Contents
