Supermicro SuperServer SYS-220GP-TNR User Manual page 67

Universal Serial Bus (USB) Ports
The motherboard has a USB 2.0 header J32 (USB2/3). This header supports two USB
connections. J32 can be used to provide front-side USB access with a cable (not included).
TPM/Port 80 Header
A Trusted Platform Module (TPM)/Port 80 header is located at JTPM1 to provide TPM support
and Port 80 connection. Use this header to enhance system performance and data security.
Refer to the table below for pin definitions. Please go to the following link for more information
on the TPM: http://www.supermicro.com/manuals/other/TPM.pdf.
Standby Power Header
The Standby Power header is located at JSTBY1 on the motherboard. You must have a card
with a Standby Power connector and a cable to use this feature. Refer to the table below
for pin definitions.
Front Panel USB 3/4 (2.0)
Pin Definitions
Pin# Definition Pin#
1 +5V 2
3 USB_N 4
5 USB_P 6
7 Ground 8
9 Key 10
Trusted Platform Module Header
Pin Definitions
Pin# Definition Pin#
1 +3.3V 2
3 RESET# 4
5 SPI_CLK 6
7 SPI_MOSI 8
9 +3.3V Stdby 10
Standby Power
Pin Definitions
Pin# Definition
1 +5V Standby
2 Ground
3 NC
67
Chapter 4: Motherboard Connections
Definition
+5V
USB_N
USB_P
Ground
NC
Definition
SPI_CS#
SPI_MISO
GND
Key
SPI_IRQ#