Supermicro SuperServer SYS-220GP-TNR User Manual page 52

Installing Front Left GPUs
1. Begin by removing power from the system. Next remove the top cover.
2. Identify the front left bracket and graphics cards as illustrated.
3. Remove the pre-installed tabs on the GPU cards.
4. Insert the GPU cards into the PCIe slot on the riser card.
5. Secure each card to the bracket using the screws that are included for this purpose.
Make sure the screws do not fall through the vent holes on the GPU cards.
6. Connect one 8-pin power cable to each GPU card. Zip-tie the power cables.
7. Carefully position each bracket in the chassis as illustrated, aligning the four mounting
holes in the top and side of each bracket with the corresponding mounting holes in the
chassis. Pay attention to the airflow arrows to install each card into the correct side of
the chassis.
8. As you are positioning the GPU bracket, route the power cables towards the
motherboard power connector by tucking the cables between the bracket and the fan.
Caution: Watch out for interference from the power cables as you are seating the GPU
bracket. Watch out for the fan, USB, and front panel cables as you are connecting the
GPU power cable.
9. Press the area on bracket above the PCIe slot firmly to ensure a good connection
between the GPU card and the motherboard.
10. Secure the bracket to the chassis by using the screws provided.
11. After the GPU card is installed, you must connect it to one of the following power
headers on the motherboard: JPW3 and JPW4.
Chapter 3: Maintenance and Component Installation
52