Supermicro SuperServer SYS-220GP-TNR User Manual page 55

Figure 3-10. Installing Front Right GPU Bracket
Installing Rear GPUs
1. Begin by removing power from the system. Next remove the top cover.
2. Identify the rear bracket and graphics cards as illustrated.
3. Keep the pre-installed tabs on the GPU cards.
4. Insert the GPU cards into the PCIe slot on the riser card.
5. Secure each card to the bracket using the screws that are included for this purpose.
Make sure the screws do not fall through the vent holes on the GPU cards.
6. Carefully position each bracket in the chassis as illustrated, aligning the four mounting
holes in the top and side of each bracket with the corresponding mounting holes in the
chassis. Pay attention to the airflow arrows to install each card into the correct side of
the chassis
7. Secure the bracket to the chassis by using the screws provided.
8. After a GPU card is installed, you must connect it to one of the following power headers
on the serverboard: JPW5 and JPW6.
Chapter 3: Maintenance and Component Installation
Direction of Airflow
Right Side GPU Bracket and Cards
55
Side Screws