To Replace The Power Line Fuse; Table 5-1 Type Of Supplied Fuse (According To Country Of Destination) - Agilent Technologies U3402A User's And Service Manual

U3402-90001.book Page 79 Friday, July 24, 2009 4:04 PM

To Replace the Power Line Fuse

U3402A User's and Service Guide
Downloaded from Elcodis.com electronic components distributor
The power line fuse is located within the multimeter's fuse- holder assembly
on the rear panel. The multimeter is shipped from the factory with a
power- line fuse installed (according to country of destination). See
If you determine that the fuse is faulty, replace it with one of the same size and
rating.

Table 5-1 Type of supplied fuse (according to country of destination)

Type of fuse (time-lag, low breaking fuse)
0.25A, 250V, 5x20 mm
0.125A, 250V, 5x20 mm
1 Disconnect the power cord. Depress tab 1 and
2 and pull the fuse holder from rear panel.
3 Rotate the line voltage selector and reinstall
it back, so that the correct voltage appears in
the fuse holder window.
100, 120, 220 (230), or 240 Vac
Disassembly and Repair
Input line voltage Part number
100 V to 120 V
A02-62-25592-3U
220 V to 240 V
A02-62-25648-1U
2 Remove the line voltage selector from fuse
holder assembly.
2
1
4 Replace fuse holder assembly in rear panel.
5
Table 5- 1.
79