Table of Contents
Advertisement
Regular safety checks
To help you fulfil the national/international requirements and to avoid malfunction and risk
for injuries, we have provided the following checklist.
Do not use if repair or adjustment is necessary.
Activate your operator and check visually, fastening of
operator
1
arm system
2
position switch
3
hinges
4
door and glass
5
Also inspect your operator and check visually for
sharp edges on the door leaf and door frame (if any)
condition of door seals
finger protection
8
and finally that the complete door runs properly and closes slowly in a smooth way
Set the programme selector in OFF mode and check that the operator and lock work together. Also
check that the lock really secures the door
Activate the manual activation units
opened sufficiently while you pass the entrance/exit.
Then proceed with the automatic activation units
Check the non-monitored safety sensors
operator. The door must not hit you when opening nor when closing. If you are unsure of which type
of sensor you have, please contact your Besam representative.
Escape
doors
Fire
doors
=
Contact your Besam representative. For contact information, see last page.
=
Take appropriate measures.
1007717-US-1.0
Daily Action
7
9
.
10
if any, and walk towards the door. Check that the door has
11
in the same way.
12
if any, by standing in the swing path and activate the
Set the programme selector in AUTO mode. Push the door manually
in escape direction and make sure that no object or function will prevent
the door from opening. Also make sure the escape route is free for use.
Let the door close after an impulse and make sure that no object will
prevent the door from closing and locking (if demanded).
Issue 2012-03-20
6
If problem
occurs
7
Advertisement
Table of Contents
