Congratulations On Your New Automatic Door; Electronic Equipment Reception Interference - Besam SW200i Owner's Manual

Swing door operator
Hide thumbs Also See for SW200i:
Table of Contents

Advertisement

Congratulations on your new automatic door!

Besam has developed automatic doors for more than 40 years. State-of-the-art technology and
carefully tested materials and components provide you with a superior product.
As with all other technical products, your automatic door requires periodic maintenance and
service. It is essential that you know your automatic door (system) and that you recognize the
importance of maintaining it in compliance with applicable standards for safety.
Your local Besam-authorized representative is familiar with these standards, as well as all ap-
plicable local codes and Besam recommendations for power-operated pedestrian doors. Service
and adjustments performed by your Besam-authorized representative, will ensure safe and
proper operation of your automatic door unit.
Failure to observe the information in this manual may result in personal injury
To reduce the risk of injury to persons - use this operator with single or double

Electronic equipment reception interference

The equipment complies with the European EMC directive (US market FCC Part 15), provided
installed according to Installation and Service manual.
The equipment may generate and use radio frequency energy and if not installed and used
properly, it may cause interference to radio, television reception or other radio frequency type
systems.
If other equipment does not fully comply with immunity requirements interference may occur.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
Re-orient the receiving antenna.
Relocate the receiver with respect to the equipment.
Move the receiver away from the equipment.
Plug the receiver into a different outlet so that equipment and receiver are on different
branch circuits.
Check that protective earth (PE) is connected.
If necessary, the user should consult the dealer or an experienced electronic technician for ad-
ditional suggestions.
1007717-US-1.0
WARNING!
or damage to equipment.
pedestrian swinging or folding doors only.
Save these instructions for future reference.
Issue 2012-03-20
3

Advertisement

Table of Contents
loading

Table of Contents