Table of Contents
Advertisement
150-819-100-03
6
Orient the 829A tool so that the locking bar faces the outboard side of the housing, then insert the 829A tool
into the plug-in position until it bottoms on the connector.
Do not attempt to force the 829A tool into the slot.
7
With the palm of your hand pressing firmly on the handle, press the locking bar and pull the retractor
backward.
8
Remove the 829A tool from the housing and visually check the connector for proper placement of the
protectors.
9
Secure the cover to the housing.
ADC does not supply the 829A extractor tool. It is available from third-party vendors.
R
EMOVING AND
1
Shut off the air supply by turning the air bypass valve counter-clockwise one-quarter turn away from the
housing.
2
Release the pressure inside the case by removing the valve core (pin) from the air stem. The core is removed
in the same manner as the valve core in an automobile tire tube.
9
3
Using a
/
-inch hand held nut drive wrench, loosen the captive bolts on the cover and remove the two covers.
16
Remove the doubler, if present.
4
Secure the cover to the housing.
5
Using a pair of pliers, remove the broken bolt from the housing.
6
Obtain a proper replacement bolt, two flat washers, and one lockwasher, and replace in the housing cover.
7
Replace the cover.
HRE-819 List 1 and 2
R
B
EPLACING
ROKEN
C
B
OVER
OLTS
July 9, 1998
Maintenance
19
Advertisement
Table of Contents
