Panduit MA002 Installation Instructions
  1. Manuals
  2. Brands
  3. Panduit Manuals
  4. Control Unit
  5. MA002
  6. Installation instructions

Panduit MA002 Installation Instructions

Inc network controller module – vertical pdu's
Hide thumbs
1
2
3

Advertisement

Table of Contents

iNC Network Controller Module – Vertical PDU's (MA002)
The iNC Network Controller Module is a hot-swappable network management card that works with the
Panduit SmartZone G5 iPDU series of intelligent power distribution units. It is the "brain" of the PDU that
contains the most complicated and sensitive electronic sub-systems. It is designed for safe removal without
disrupting the PDU hardware operation.
The below instructions also apply for Panduit Upgradable G5 iPDUs, when replacing the blanking panel with
an iNC Network Control Module.
Note: The iNC Network Control Modules are designed to connect to a SmartZone G5 iPDU only.
Connecting it to another device may result in damage.
INVENTORY:
INSTALLATION INSTRUCTIONS:
1. Remove all connections from the front of the existing iNC Network
Control module (Ethernet, Serial, Sensor, etc.) and document which port
each of the RJ45 plugs were connected to as you will need to reconnect
the wires to the same ports.
2. Using a T10 screwdriver, loosen the (2) screws securing the iNC
Network Control Module or Upgradable iPDU Blanking Panel
World Headquarters U.S.A.
IM037 Rev. 04
iNC CONTROLLER
|
18900 Panduit Drive
|
Upgradable iPDU
Blanking Panel
USB
DRIVE
Tinley Park, IL 60487
|
P: 800-777-3300
RIBBON CABLE
|
www.panduit.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MA002 and is the answer not in the manual?

Questions and answers

Related Manuals for Panduit MA002

Summary of Contents for Panduit MA002

  • Page 1 The iNC Network Controller Module is a hot-swappable network management card that works with the Panduit SmartZone G5 iPDU series of intelligent power distribution units. It is the “brain” of the PDU that contains the most complicated and sensitive electronic sub-systems. It is designed for safe removal without disrupting the PDU hardware operation.
  • Page 2 3. Remove the iNC Network Control Module or Upgradable iPDU Blanking Panel from the PDU chassis 4. For iNC Network Control Module removal – disconnect the iNC Network Control module ribbon cable from the PDU chassis. 5. Plug the ribbon Cable into the replacement iNC Network Controller module 6.
  • Page 3 Locate the Panduit.FW file in the archive and Save to the root directory of the USB Drive 3. Insert the USB Drive into the USB port of the iNC Network Controller 4. To Enter USB mode on the PDU: Press Select / Go to Setup > USB > Yes. Select Yes to confirm entering USB mode.

Table of Contents