Panduit MA002 Installation Manual

iNC Network Controller Module – Vertical PDU's (MA002)
The iNC Network Controller Module is a hot-swappable network management card that works with the Panduit
SmartZone G5 iPDU series of intelligent power distribution units. It is the "brain" of the PDU that contains the most
complicated and sensitive electronic sub-systems. It is designed for safe removal without disrupting the PDU
hardware operation.
Note: The iNC Network Control Modules are designed to connect to a SmartZone G5 iPDU only. Connecting it to
another device may result in damage.
INVENTORY:
NETWORK CONTROLLER
INSTALLATION INSTRUCTIONS:
1. Using a T10 screwdriver, loosen the (2) screws securing the iNC
Network Control Module in place
2. Remove the iNC Network Control Module from the PDU chassis
3. Press the release button on the iNC Network Control module cable that
plugs into the PDU and disconnect
4. Remove all connections from the front of the existing iNC Network
Control module (Ethernet, Serial, Sensor, etc.) and plug them into the
front of the replacement iNC Network Control module
NOTE: It is recommended to disconnect and reconnect ports
immediately to insure the cables are plugged into the same ports as
before
Customer Service: CS@panduit.com 800.777.3300-Technical Support: techsupport@panduit.com 866.405.6654
USB
DRIVE
CABLE
page 1
IM037 REV 00