Toyota Corolla Hatchback 2023 Manual page 295

sure of each tire on the multi-infor-
mation display.
9
Drive straight (with occa-
sional left and right turns) at
approximately 25 mph (40
km/h) or more for approxi-
mately 10 to 30 minutes.
When registration is complete, the
tire pressure warning light will turn
off and a message indicating that
registration has been completed
will be displayed on the multi-infor-
mation display.
Registration may take longer than
normal to complete if the vehicle
speed cannot be maintained at
approximately 25 mph (40 km/h) or
more. If registration cannot be com-
pleted after driving for 1 hour or
more, perform the registration pro-
cedure again from the beginning.
10If the tire inflation pressure of
the wheel set installed differs
from that of the previous set,
it will be necessary to per-
form the tire inflation pres-
sure setting procedure of the
tire pressure warning system.
If the specified tire inflation pres-
sure is the same, it will not be nec-
essary to perform the tire inflation
pressure setting procedure.
7-inch display

1
Park the vehicle in a safe
place and turn the engine
switch off, wait for approxi-
mately 20 minutes or more,
and then start the engine.
The ID code registration procedure
cannot be performed while the
vehicle is moving.
6-3. Do-it-yourself maintenance
2
Select
mation display and then
press .
3
Press or
"Vehicle Settings" and then
press and hold
4
Press or
"TPWS setting" and then
press .
5
Press or
"Tire Set Switching" and then
press .
6
Press or
"Register New Valve / ID" and
then press
7
Press or
"Tire Set 1" or "Tire Set 2".
Then press
ID codes will be registered to the
displayed wheel set.
If ID codes have already been reg-
istered for that wheel set, the tire
pressure warning light will slowly
blink 3 times, and a message indi-
cating that change is occurring will
be displayed on the multi-informa-
tion display.
295
of the multi-infor-
to select
.
to select
to select
to select
.
to select
.
6