Toyota Corolla Hatchback 2023 Manual page 290

290
6-3. Do-it-yourself maintenance
position registration may take lon-
ger than usual to be completed or
may not be possible.
• Vehicle is not driven at approxi-
mately 25 mph (40 km/h) or more
• Vehicle is driven on unpaved
roads
• If wheel position registration does
not complete after driving for 1
hour or more, park the vehicle in a
safe place for approximately 15
minutes and then drive the vehicle
again.
● If the vehicle is reversed during
wheel position registration, all
data collected until then will be
cleared. Perform driving again.
Setting the tire pressure
In the following situations, it will
be necessary to perform the tire
inflation pressure setting proce-
dure of the tire pressure warning
system.
 When the specified tire infla-
tion pressure has changed,
such as due to carried load,
etc.
 When the tire inflation pres-
sure is changed such as
when the tire size is changed.
If the tire inflation pressure has
been adjusted to the specified
level, perform the tire inflation set-
ting procedure by selecting speci-
fied inflation pressure on the
multi-information display.
When the tire inflation pressure is
to be other than specified, such as
when tires other than the specified
size are used, etc., set the tire infla-
tion pressure using the current
pressure. Make sure to adjust the
tire inflation pressure of each tire to
the appropriate level before per-
forming tire pressure setting. The
tire pressure warning system oper-
ates based on this tire inflation
pressure.
Setting by selecting a spec-
■
ified tire inflation pressure
4.2-inch display

1
Park the vehicle in a safe
place and then start the
engine.
The tire inflation pressure cannot
be set while the vehicle is moving.
2
Select of the multi-infor-
mation display and then
press .
3
Press or
"Vehicle Settings" and then
press and hold
4
Press or
"TPWS setting" and then
press .
5
Press or
"Tire Pressure Setting" and
then press .
6
Press or
"Setting by Specified Pres-
sure" and then press
7
Select the desired tire pres-
sures, then press
The tire pressure warning light will
slowly blink 3 times.
After setting the tire inflation pres-
to select
.
to select
to select
to select
.
.