Toyota Corolla Hatchback 2023 Manual page 198

198
4-5. Using the driving support systems
(If the vehicle has been stopped by
system control, depressing the
brake pedal will not cancel control.)
Changing the vehicle-to-vehicle distance
Each time the switch is pressed, the vehicle-to-vehicle distance set-
ting will change as follows:
If a preceding vehicle is detected, the preceding vehicle mark will be dis-
played.
Illustration Vehicle-to-vehicle
Number
1
2
3
4
The actual vehicle-to-vehicle distance varies in accordance with the vehicle
speed. Also, when the vehicle is stopped by system control, it will be
stopped at a certain distance from the preceding vehicle, depending on the
situation, regardless of the setting.
■ Operating conditions
● The shift lever is in D.
● The desired set speed can be set
when the vehicle speed is approx-
imately 20 mph (30 km/h) or more.
• If the vehicle speed is set while
driving at below approximately 20
mph (30 km/h), the set vehicle
speed will be approximately 20
mph (30 km/h).
• If the vehicle speed is set while
driving at a speed that exceeds
2
Press the "RES" switch to
resume control.
Approximate Distance (Vehicle
distance Speed: 60 mph [100 km/h])
Extra long Approximately 200 ft. (60 m)
Long Approximately 145 ft. (45 m)
Medium Approximately 100 ft. (30 m)
Short Approximately 85 ft. (25 m)
the system's upper limit, the set
vehicle speed will be the system's
upper limit.
■ Accelerating after setting the
vehicle speed
As with normal driving, acceleration
can be performed by depressing the
accelerator pedal. After accelerat-
ing, the vehicle will return to the set
vehicle speed. However, while in
vehicle-to-vehicle distance control
mode, the vehicle speed may