■
Turning off both TRAC and VSC
systems
To turn the TRAC and VSC systems
off, press and hold
than 3 seconds while the vehicle is
stopped.
The VSC OFF indicator light will
come on and the "Traction Control
Turned OFF" will be shown on the
multi-information display.
Press
again to turn the system
back on.
*
: PCS will also be disabled (only
Pre-Collision warning is avail-
able). The PCS warning light will
come on and a message will be
displayed on the multi-information
display. (P.176)
■
When the message is dis-
played on the multi-information
display showing that TRAC has
been disabled even if
not been pressed
TRAC is temporary deactivated. If
the information continues to show,
contact your Toyota dealer.
■
Operating conditions of
hill-start assist control
When all of the following four condi-
tions are met, the hill-start assist
control will operate:
●
The shift lever is in a position
other than P or N (when starting
off forward/backward on an
upward incline).
●
The vehicle is stopped
●
The accelerator pedal is not
depressed
●
The parking brake is not engaged
●
The engine switch is turned to ON
■
Automatic system cancelation
of hill-start assist control
The hill-start assist control will turn
4-5. Using the driving support systems
off in any of the following situations:
●
The shift lever is shifted to P or N.
●
The accelerator pedal is
depressed
for more
●
The parking brake is engaged
●
2 seconds at maximum elapsed
after the brake pedal is released
●
The engine switch is turned to
OFF
*
■
Sounds and vibrations caused
by the ABS, brake assist, VSC,
TRAC and hill-start assist con-
trol systems
●
A sound may be heard from the
engine compartment when the
brake pedal is depressed repeat-
edly, when the engine is started or
just after the vehicle begins to
move. This sound does not indi-
cate that a malfunction has
occurred in any of these systems.
●
Any of the following conditions
may occur when the above sys-
tems are operating. None of these
indicates that a malfunction has
has
occurred.
• Vibrations may be felt through the
vehicle body and steering.
• A motor sound may be heard also
after the vehicle comes to a stop.
■
Active Cornering Assist opera-
tion sounds and vibrations
When the Active Cornering Assist is
operated, operation sounds and
vibrations may be generated from
the brake system, but this is not a
malfunction.
■
EPS operation sound
When the steering wheel is oper-
ated, a motor sound (whirring
sound) may be heard. This does not
indicate a malfunction.
■
Automatic reactivation of TRAC
and VSC systems
After turning the TRAC and VSC
systems off, the systems will be
automatically re-enabled in the fol-
lowing situations:
227
4