a safe place and leave it with the
engine switch in ON for approxi-
mately 15 minutes or more, and
then perform the driving procedure
again.
7-inch display
1
Park the vehicle in a safe
place and turn the engine
switch off, wait for approxi-
mately 20 minutes or more,
and then start the engine.
The wheel position registration pro-
cedure cannot be performed while
the vehicle is moving.
2
Select
of the multi-infor-
mation display and then
press
.
3
Press
or
to select
"Vehicle Settings" and then
press and hold
4
Press
or
to select
"TPWS setting" and then
press
.
5
Press
or
to select
"Tire Rotation" and then
press
.
6
Select "OK" and then press
.
A message indicating that wheel
position registration is being per-
formed will be displayed on the
multi-information display. "---" will
be displayed for the tire inflation
pressure of each tire and wheel
position registration will begin.
7
Drive straight (with occa-
sional left and right turns) at
6-3. Do-it-yourself maintenance
approximately 25 mph (40
km/h) or more for approxi-
mately 10 to 30 minutes.
When wheel position registration is
complete, a message indicating
that registration has been com-
pleted and the inflation pressure of
each tire will be displayed on the
multi-information display.
Even if it is not possible to drive
continuously at approximately 25
mph (40 km/h) or more, registration
can be completed by driving for a
long time. However, if registration
does not complete after driving for
1 hour or more, park the vehicle in
a safe place and leave it with the
engine switch in ON for approxi-
mately 15 minutes or more, and
then perform the driving procedure
again.
■
When performing wheel posi-
tion registration
●
Normally, wheel position registra-
.
tion can be completed within
approximately 30 minutes.
●
Wheel position registration is per-
formed while driving at a vehicle
speed of approximately 25 mph
(40 km/h) or more.
■
Wheel position registration pro-
cedure
●
If the engine switch is turned off
while registering the wheel posi-
tion, the next time the engine
switch is turned to ON, the wheel
position registration will resume
and it will not be necessary to
restart the procedure.
●
While the position of each wheel is
being determined and the inflation
pressures are not being dis-
played, if the inflation pressure of
a tire drops, the tire pressure
warning light will come on.
■
If the wheel position cannot be
registered easily
●
In the following situations, wheel
289
6