Tuning Into A Preset Station - JVC NX-MD1 Instructions Manual

To preset stations manually—Manual Presetting
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 2
again.
On the remote control ONLY:
1
Tune into the station you want to preset.
• See "Tuning into a Station" on page 17.
2
Press SET.
The preset number 1 starts flashing.
3
Press the number buttons to select a preset number.
Ex. For preset number 5, press 5.
For preset number 15, press +10, then 5.
For preset number 20, press +10, then 10.
Ex. When number 5 is selected
for a new preset station
4
Press SET again.
"STORED" appears in the main display.
The tuned station in step 1 is stored in the preset
number selected in step 3.
• Storing a new station on a used number erases the
previously stored one.
When you unplug the AC power cord or if a power
failure occurs
The preset stations will be erased in a few days. If this happens,
preset the stations again.

Tuning into a Preset Station

1
Press FM/AM.
The unit automatically turns on and tunes into the
previously tuned station (either FM or AM–MW/LW).
• Each time you press the button, the band alternates
between FM and AM (MW/LW).
2
Select a preset number.
On the remote control:
Press the number buttons.
Ex. For preset number 5, press 5.
For preset number 15, press +10, then 5.
For preset number 20, press +10, then 10.
On the unit:
Press 7 repeatedly.
Each time you press the button, the preset number
increases in order. If you press the button at the last
preset number, the preset number will start from
number 1.
Ex. When number 5 is selected
– 18 –
Continued