Tuning Into A Station; Presetting Stations - JVC NX-MD1 Instructions Manual

Tuning into a Station

1
Press FM/AM.
The unit automatically turns on and tunes into the
previously tuned station (either FM or AM–MW/LW).
• Each time you press the button, the band alternates
between FM and AM (MW/LW).
2
Tune into a station.
On the remote control:
Press and hold ¡/¢ or 4/1 until the station
frequencies start changing in the main display.
• ¡/¢ : to increase the frequencies.
• 4/1 : to decrease the frequencies.
On the unit:
Press and hold ¢ or 4 until the station
frequencies start changing in the main display.
• ¢ : to increase the frequencies.
• 4 : to decrease the frequencies.
The unit starts searching for stations and stops when a
station of sufficient signal strength is tuned in.
• If an FM program is broadcast in stereo, the STEREO
indicator lights.
To stop during searching, press ¡/¢ or 4/1
(¢ or 4 on the unit).
When you repeatedly press ¡
¢ ¢ ¢ or 4 4 4 on the unit) 4
¢ 4
(¢
The frequency changes step by step.
To change the FM reception mode
When an FM stereo broadcast is noisy or hard to receive,
you can change the FM reception mode to improve the
reception.
On the remote control ONLY:
Press FM MODE.
• Each time you press the button, FM reception mode
alternates between "FM AUTO" and "FM MONO."
FM AUTO : Normally select this. In this mode, you
can hear stereo sound when a program is
broadcast in stereo.
FM MONO : Select this when an FM stereo broadcast
is noisy or hard to receive. Reception
improves though stereo effect is lost.
The MONO indicator lights up on the
display.
¡ /¢ ¡ ¡ ¡ ¢ or 4 ¢ ¢ ¢ 4 4 /1 4 4 1 1 1 1
– 17 –
To change the information shown in the main
display
On the remote control ONLY:
Each time you press DISP./CHARA, the information in the
main display alternates between the source indication and
the clock indication.

Presetting Stations

You can preset 30 FM and 15 AM (MW/LW) stations—
using either automatic presetting method or manual
presetting method.
In some cases, test frequencies have been already memorized
for the tuner since the factory examined the tuner preset
function before shipment. This is not a malfunction. You can
preset the stations you want into memory by following the
presetting method.
To preset stations automatically—Automatic Presetting
On the remote control ONLY:
You need to preset stations separately for the FM and AM
bands.
1
Press FM/AM to select the band.
2
Press and hold AUTO PRESET for about 2 seconds
until "AUTO PRESET" appears in the main
display.
Local stations with strong signals are searched for and
stored in memory automatically.
When automatic presetting is over, the station stored in
preset number 1 is received.
3
Repeat steps 1 and 2 to store stations of the other
band.
When you cannot store stations you want
automatically
Stations with weak signals cannot be detected with this automatic
presetting method. To store such a station, use the manual
presetting method on page 18.