Preparations And Start-Up; Function Check - Physiomed CHUDO HIVAMAT 200 Personal Manual

4 Instrument Operation

4.2 Preparations and Start-Up

How to Start up the Instrument
(1) Insert the therapy card with the chip side facing down into the Card Reader <4>.
Important
If the card is defective or incompatible, a respective error message will be displayed.
(2) Press the Data Selector <2> for about two seconds. You will hear an acoustic signal, the Display
<1> will be illuminated, and the start screen with the menu will be displayed:
Start Screen
You can now select an indication and begin the treatment (refer to
indications
How to Switch off the Instrument
(1) Press the Data Selector <2> for about five seconds. The Display <1> goes out.
(2) Remove the therapy card and unplug the cables from the Ports <3>.

4.3 Function Check

A function check is always necessary when you are unsure about whether the instrument is working prop-
erly.
How to Check the Function of the Instrument
(1) Press the Data Selector <2> for several seconds until the instrument switches off.
(2) Press the Data Selector <2> again until the instrument switches on:
• If the instrument is properly working, the available options are displayed on the Display <1>.
You can operate the instrument without any further precaution.
• If an error code is displayed, there is an instrument error. Proceed as described under
Notes
HIVAMAT ™ 200 Personal
on page 16).
on page 15.
PHYSIOMED ELEKTROMEDIZIN AG
How to perform a treatment with
Monitoring
11