Table of Contents
Advertisement
Quick Links
Single Monitor Desk Mount with Extra Long Arm
Instruction Manual
SKU: STAND-V101N
Scan the QR code with your mobile device or follow the link
for helpful videos and specifications related to this product.
https://vivo-us.com/products/stand-v101n
GET IN TOUCH | Monday-Friday from 7:00am-7:00pm CST
help@vivo-us.com
www.vivo-us.com
Chat live with an agent!
309-278-5303
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Vivo STAND-V101N
Summary of Contents for Vivo STAND-V101N
- Page 1 Single Monitor Desk Mount with Extra Long Arm Instruction Manual SKU: STAND-V101N Scan the QR code with your mobile device or follow the link for helpful videos and specifications related to this product. https://vivo-us.com/products/stand-v101n GET IN TOUCH | Monday-Friday from 7:00am-7:00pm CST help@vivo-us.com...
- Page 2 WARNING! If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual.
- Page 3 ASSEMBLY STEPS STEP 1 Insert Pole Cap (D) into the top of Pole (C). STEP 2 OPTION A: Clamp Installation Mount Pole (C) to Clamp (B) using M6x16mm Screws (S-A). Tighten using 4mm Allen Wrench (T-A). Apply the Rubber Pads (I) to the underside of Clamp (B), then attach Clamp (B) to the desktop.
- Page 4 STEP 3 Slide Pole Cable Clip (H) and Arm (A) onto Pole (C). Secure Arm (A) to Pole (C) using 5mm Allen Wrench (T-B). STEP 4 Attach Arm Cable Clips (F) to Arm (A) as shown.
- Page 5 STEP 5 Insert two screws (M-A or M-B) and M5 Washers (M-C) into the top mounting holes of the monitor, making sure to leave 3mm of thread exposed. Align screws in monitor over the slots in the VESA plate. Secure using two more Screws (M-A or M-B) and M5 Washers (M-C) in the bottom two holes of the monitor.
- Page 6 STEP 6 Adjust the tilt joint using 6mm Allen Wrench (T-C). STEP 7 Store 5mm Allen Wrench (T-B) and 6mm Allen Wrench (T-C) in Pole Cable Clip (H) for future adjustments.
- Page 7 STEP 8 Tighten the joints in Arm (A) using 8mm Allen Wrench (T-D) with 19mm Wrench (T-E) and 6mm Allen Wrench (T-C). STEP 9 Route cables through Arm Cable Clips (F) and Pole Cable Clips (H).
- Page 8 AVG. RESPONSE TIME (within office hrs) - 23% within < 15m - 38% within < 30m - 61% within < 1hr - 83% within < 2hr - 92% within < 3hr FOR MORE VIVO PRODUCTS, CHECK OUT OUR WEBSITE AT: www.vivo-us.com...
Need help?
Do you have a question about the STAND-V101N and is the answer not in the manual?
Questions and answers