Dab Operation; Dab Auto Scan - Sandstrom SVDB12E Instruction Manual

DAB Operation

If the unit is connected to the mains power and then
switched on from standby for the first time, the unit
will automatically enter the DAB mode and start
automatically scanning. During the scan the LCD
display will show "Scanning..." together with a slide
bar that indicates the progress of the scan and the
amount of stations that have been found so far.
Once the scan has finished, the unit will select the first
alphanumerically found station. Explore the found
stations by turning the SCROLL dial. When you find a
station that you would like to listen to, press the OK
dial.
GB
If there are no stations found after auto scan, the radio will enter the
Tune Select Menu, you can now turn the SCROLL dial then press OK
dial to select "Manual tune" or "Autoscan" for stations.

DAB Auto Scan

The auto scan will search for the all DAB Band III channels. After the scan has finished, the
first alphanumerically found station will be automatically selected.
Full auto scan will not replace the DAB stations in the unit's memory. If you
want to delete all the previously scanned stations, a system reset is required.
To activate auto scan, first press the MENU button
1.
to enter the Tune Select Menu. Then turn the
SCROLL dial to select "Autoscan", and then press
the OK dial to confirm. The display will show
"Scanning ..." and a progressing slide bar. This may
take a few minutes, depending on the number of
stations found.
2. All the stations that have been found will be
stored automatically. To explore the found
stations, turn the SCROLL dial. Press the OK dial
to confirm.
12