Dab Operation; Dab Auto Scan; Secondary Services - Sandstrom S9DABI12 Instruction Manual

DAB Operation

If the unit is connected to the mains power and then switched on from standby for the first
time, the unit will automatically enter DAB mode and start automatically scanning. During
the scan the LCD display will show "Scan XXX"
Once the scan has finished, the unit will select the first alphanumerically found station.
Explore the found stations by pressing
If auto scan is not sufficient, you can use manual tuning.

DAB Auto Scan

The auto scan will search for the all DAB Band III channels. After the scan has finished, the
first alphanumerically found station will be automatically selected.
Full auto scan will not replace the DAB stations in the unit's memory. If you
want to delete all the previously scanned stations, a system reset is required.
To activate auto scan, press SET on the remote control,
1.
then ENTER. The display will show "SCAN XXX" while
scanning. When a DAB station is found the display will
show "FOUND (No. of station)".
2. All the stations that have been found will be stored
automatically. Press
then ENTER to listen to the desired station.

Secondary Services

• Press on the remote control to access the station's secondary services if available.
• Press on the remote control again to skip to the next station's secondary services (if
available).
on the remote control, then ENTER.
on the remote control,
DAB
17