Wilson Electronics WeBoost Drive Reach RV Installation Manual page 17

Specifications
Model
FCC
Connectors
Antenna lmpedence
Frequency
Power output for single cell
phone (Uplink) dBm
Pow er output for single cell
phone (Downlink) dBm
Noise Figure
Isolation
Power Requirements
Drive Reach Cell Signal Booster
470061
PWO460061
SMB~ Jack
50 Ohms
698~716 MHz, 728 •756 MHz.
m-787
MHz. 824-894 MHz, 1850-1995 MHz, 1710-1755/211~2155 MHz
700 MHz B12/17
25.4
4.8
700MHzB13
25.6
4.8
800
MHz BS
25.6
4.8
5 dB
(nominal)
> 9 0 d8
5V, 4.5A
1700MHz B4
26.7
4.6
1900MHz B2
26.9
4.5
Each Signal Booster is Individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be adjusted without factory reprogramming or disabling the
hardware. The Signal Booster will amplify, but not alter incoming and outgoing signals in order
to
increase coverage of authorized frequency bands only. If the Signal Booster
is not in use for five minutes, it will reduce gain until a signal is detected. If a detected signal is too high in a frequency band, or if the Signal Booster detects an oscillation, the
Signal Booster will automatically turn the power off on that band. For a detected oscillation the Signal Booster will automatically resume normal operation after a minimum of
1 minute. After 5 (five) such automatic restarts, any problematic bands are permanently shut off until the Signal Booster has been manually restarted by momentarily removing
power from the Signal Booster. Noise power. gain, and linearity are maintained by the Signal Booster's microprocessor.
This device complies with Part 15 of FCC rules. Operation is subject to two conditions: (1 ) This device may not cause harmful Interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by weBoost could void the authority to
operate this equipment.
■