Plc Power And I/O Cable - Basler GIGE VISION ace acA640-100gm/gc Manual

5.4.3
As with the standard power and I/O cable described in the previous section, the PLC power and
I/O cable is a single cable that both connects power to the camera and connects to the camera's
I/O lines. The PLC power and I/O cable adjusts the voltage levels of PLC devices to the voltage
levels required by the camera and it protects the camera against negative voltage and reverse
polarity.
If you supply power to the camera via Power over Ethernet (PoE) and you also supply power to the
camera's 6-pin connector via a PLC power and I/O cable, the camera will use the power supplied
to the 6-pin connector. Power supplied to the camera's 6-pin connector always has priority, and the
power supplied to the 6-pin connector must meet the specifications outlined in the "Camera Power"
section of this manual.
Close proximity to strong magnetic fields should be avoided.
Basler offers a PLC power and I/O cable that is terminated with a 6-pin Hirose plug (HR10A-7P-6S)
on the end that connects to the camera. The other end is unterminated. Contact your Basler sales
representative to order the cable.
For information about the applicable voltage levels, see Section 5.7.1.1 on
Basler ace
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from

PLC Power and I/O Cable

Note
We recommend using a PLC power and I/O cable if the camera is connected
to a PLC device.
If power for the I/O input is supplied at 24 VDC, you can use a PLC power and
I/O cable when the camera is not connected to a PLC device.
Physical Interface
page 34.
31