Table of Contents
Advertisement
• Circuit Boards Location
MD DIGITAL board
PANEL board
LOADING board
AMP board
SP board
TUNER UNIT
MAIN board
POWER board
SW board
BD (MD) board
BD (CD) board
6-5.
NOTE FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS
(In addition to this, the necessary note is printed in each block)
Note on Printed Wiring Boards:
• X : parts extracted from the component side.
• Y : parts extracted from the conductor side.
• b : Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side:
Parts on the pattern face side seen from
(Side B)
the pattern face are indicated.
Parts face side:
Parts on the parts face side seen from
(Side A)
the parts face are indicated.
• Indication of transistor.
C
Q
These are omitted.
B
E
Q
B
C E
These are omitted.
43
43
Note on Schematic Diagram:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and
1
/
W or less unless otherwise
4
specified.
•
f
: internal component.
• 2 : nonflammable resistor.
• 5 : fusible resistor.
• C : panel designation.
Note: The components identified by mark 0 or dotted line
with mark 0 are critical for safety.
Replace only with part number specified.
• U : B+ Line.
• V : B– Line.
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
F
: TUNER
J
: CD PLAY
E
: MD PLAY
j
: MD REC (ANALOG)
l : MD REC (DIGITAL)
d
: TAPE IN (PLAY)
G
: TAPE OUT (REC)
• Abbreviation
HK
: Hong Kong model
KR
: Korean model
TW
:Taiwan model
Advertisement
Table of Contents
